Aps Designer 6.0 Marathi Software
(Optional) On the 802.11g radio, enter speed throughput ofdm to set all OFDM rates (6, 9, 12, 18, 24, 36, and 48) to basic (required) and set all the CCK rates (1, 2, 5.5, and 11) to disabled. When you enter throughput, the wireless device sets all data rates to basic. When you enter range, the wireless device sets the lowest data rate to basic and the other rates to enabled. (no ERP protection) to automatically optimize radio range or throughput. (Optional) Alternatively, enter range or throughput or If you select 12 Mbps or higher for the basic data rate on the 802.11g radio, 802.11b client devices cannot associate to the wireless device 802.11g radio.Įnter basic-6.0, basic-9.0, basic-12.0, basic-18.0, basic-24.0, basic-36.0, basic-48.0, and basic-54.0 to set these data rates to basic on the 5-GHz radio. Note The client must support the basic rate that you select or it cannot associate to the wireless device. Set each data rate to basic or enabled, or enter range to optimize range or throughput to optimize throughput. Shutdown-the wireless device shuts down its radio and disassociates all client devices.Įnter interface configuration mode for the radio interface:Ģ.4-GHz radio and the 802.11n 2.4-Ghz radio is interface 0.ĥ-GHz radio and the 802.11n 5-GHz radio is interface 1.You do not have to specify a root access point to which the fallback repeater associates the repeater automatically associates to the root access point that provides the best radio connectivity. Repeater-When the Ethernet port is disabled, the wireless device becomes a repeater and associates to a nearby root access point.The wireless device automatically assumes the fallback role when its Ethernet port is disabled or disconnected from the wired LAN. You can also configure a fallback role for root access points. You can configure the role of an access point or bridge in a radio network. This configuration results in a mismatch in the multicast cipher between the root and non-root devices. The non-root device will not associate with the root if it is configured only AES-CCM. When configuring a universal workgroup bridge using AES-CCM TKIP, the non-root device should use only TKIP or AES-CCM TKIP as ciphers in order to associate to the root device.
![Aps Designer 6.0 Marathi Software Aps Designer 6.0 Marathi Software](https://m.media-amazon.com/images/I/81N50KTztXL._SX425_.jpg)
Enabling Short Slot Time for 802.11g Radiosġ.Configuring the Fragmentation Threshold.Configuring the Maximum Data Packet Retries.Configuring the Beacon Period and the DTIM.Enabling and Disabling Public Secure Packet Forwarding.Enabling and Disabling Reliable Multicast to Workgroup Bridges.Configuring the Ethernet Encapsulation Transformation Method.Disabling and Enabling Aironet Extensions.Enabling and Disabling Gratuitous Probe Response.Configuring Transmit and Receive Antennas.Disabling and Enabling Short Radio Preambles.
![Aps Designer 6.0 Marathi Software Aps Designer 6.0 Marathi Software](https://generousegg.weebly.com/uploads/1/2/3/8/123827629/876078442.png)